|
|
|
|
The operator can select the lumber with the use of a touch screen monitor and selecting the lumber characteristics based on your mills preference. In this video, the operator first selects the unit layout. (For example if the pack is ten high or sixteen high, one, two or three packs. ) Next the operator selects the thickness and width. The next screen will allow the operator to insert location of lathe placement in a unit. The following screen allowed the operator to select to use two of four guns in the tagging process. Finally the question is "Is this the correct Lumber" describing the units to tag. Watch the video and remember that this will be organized to fit your mills needs Click the link on the left to view the video. |
|
Send mail to innovative@knology.net with
questions or comments about this web site.
|
